Dometic RM 4601 Betriebsanleitung PDF herunterladen (Seite 15)

A length of sealing strip is applied to the rear surface of

the front frame for this purpose, see fig. 2.

Note: A wood strip must be in place across the upper

opening of the enclosure. The top frame of the refrigera-

tor will be anchored to the wood strip with screws. See

fig. 6 b.

Push the refrigerator into the recess until the sealing strip

on the flange seals against the front of the recess, so

that the cooling unit is completely sealed off against the

interior of the caravan.

Note: Be careful not to damage the sealing strip when

the refrigerator is put in place.

Securing the refrigerator

After the refrigerator is put in place, (insuring a combus-

tion seal at the front frame), the refrigerator is to be se-

cured in the enclosure with six screws. The screws have

to be installed in the following order:

STEP 1: Two screws installed through the front base.

1. Secure the refrigerator to the floor with two screws:

One screw through the hinge and into the floor, and

on the opposite side one screw through the front

base. (See fig. 3).

2. A cover plate (shipped as a loose part) is to be

attached after the refrigerator is secured in the

enclosure. (See fig. 3).

STEP 3: Two screws installed in the rear base.

See fig. 5.

Failure to follow the sequence in securing the refrigera-

tor in the enclosure can cause leakage between the frame

and cabinet. Any space between the counter, storage

area or ceiling and top of the refrigerator greater than 40

mm should be blocked. The heat produced at the rear of

the refrigerator will become trapped in this space, mak-

ing the top of the refrigerator hot and reduce the effi-

ciency of the refrigerator.

STEP 2: Two screws installed in the top frame.

The top decoration panel must be removed from the re-

frigerator before the screws can be installed. Open the

upper door and gently push the tabs out of the hole in

the hinge (both sides) with a flat blade screwdriver. Care-

fully tilt the top decoration panel and lift up to remove

from top frame. See fig. 4.

Install the two screws in the top frame, the holes are

accessible from underneath.

Seal the opening for the screws with aluminium tape.

Replace the top decoration panel. Make sure the tabs

snap back into the holes in the hinge plate.

FIG. 3

FIG. 4

FIG. 5

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Dometic RM 4601 Betriebsanleitung Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kühlschränke Dometic RM 4601