Dometic DS300FS Bedienungsanleitung PDF herunterladen (Seite 7)

4. Only

the entire cooling unit must project into

the duct as shown

5. Air passing thr

ough the duct must not be

eheated by any source of heat

6. Ventilation grills, if used, must have openings

of at leas

t 200cm

each

During installation, please ensure the mains plug

is accessible at all times.

5. Using the appliance

To start the refrigerator connect the plug to the socket

outlet and switch on the socket. The cooling fins should

show signs of cooling after about 1-2 hours depending

on ambiant temperature.

5.1. Initial operation

The device must be plugged into a properly earthed

socket.

The miniCool starts automatically with a self-test.

The LED illuminates after plugging-in several times

and after that continuous light can be seen if the

door is open.

The miniCool achieves its operating temperature

after several hours.

5.2. Temperature regulation

The usual setting required is in the region of the middle

of the thermostat knob (Fig. 6), but this can vary with

conditions of load and installation. If it is found

necessary to alter the setting,the knob can be turned

to a higher symbol to produce a colder temperature, or

a lower symbol to produce a warmer temperature. The

effect of any adjustment can be checked by means of

a thermometer after leaving the refrigerator operating

for a further period to settle down again.

Figure 6.

6. Useful suggestion

Do not overfill the appliance. It is advisable to leave

some space between the products in the cabinet to

ensure efficient and even cooling. If the shelves are

packed too tightly there may be unacceptable

temperature variations.

7. Defrosting, cleaning and

maintenance

Frost will gradually form on the cooling surfaces

and it must not be allowed to become too thick

since it acts as an insulator and interferes with the

cooling.

The miniCool is fitted with a fully automatic, electronic

temperature regulator.

The frost will melt and the defrost water will run

through the drain tube from the drip channel into an

evaporating vessel located at the bottom rear of the

refrigerator. (Fig 7) The defrost water will evaporate

automatically into the circulating air and the vessel

will not need emptying manually.

If we want to switch off the unit, disconnect the

refrigerator from the electricity supply and leave the

cabinet door open. After defrosting the cabinet

interior should be wiped out with a clean, damp

cloth.

7.1. Automatic defrost function

The first defrosting phase commences 39 hours

after the initial operation and lasts for two hours.

After this, the device operates for 22 hours at a

time, followed by a defrosting period of 2 hours.

8. Interior light

Two light-emitting diodes (A) on an electronic PCB

illuminate the cooling compartment when the door

is opened.

Two sensors (B) control whether the door is open

or not and the LEDs will work accordingly.

Figure 8.

Figure 7.

Figure 5.

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Dometic DS300FS Bedienungsanleitung Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Dometic DS300FS