9
5. Plan ush switch panel and electronic control module loca-
tions so that electrical connections can be made with cables
provided with toilet. Be sure module and wires cannot get wet.
Note
Several ush switch options are available from Dometic.
Instructions for installing the Dometic ush switch follow.
Other available types t either Vimar or Gewiss ush switch/
status panel components. Instructions for these are included
with each ush switch assembly.
6. Use Dometic wall switch template to mark location of
fastener and access holes. Drill 1 in. (25 mm) hole, then
fasten panel bracket to wall (g.
12
).
7. Route Dometic ush switch panel cable from
control module to access hole at ush switch
panel location. Attach cable to ush switch
panel, then snap the panel cover onto the panel
bracket (g.
12
).
8. Install control module in cool, dry location and
attach Dometic ush switch cable to control
module (g.
13
, page 10).
9. With electrical power off, complete wiring con-
nections to control module. Refer to Section 5.6,
Wiring schematic.
10. Route control module cable to toilet through
access hole in oor.
Caution! Hazard of Flooding
If toilet uses raw water for ushing at ANY time, a raw water pump controlled by an automatically operat-
ing demand switch MUST NOT be installed. If the onboard water valve or any plumbing connections
were to leak, the automatically operated pump would start and could ood the boat. Failure to comply
with this warning can cause loss of property and life.
5.3 Toilet system with through-the-floor connections
1. Place oor mounting template in desired location (g.
10
).
For optimal user comfort, make sure walls or other interior
xtures are at least 11 in. (279 mm) away from centerline of
template.
2. Center punch all holes and mounting bracket corners
through template.
3. Remove template from oor. Drill all access and fastener
holes as indicated on template. DO NOT drill mounting
bracket corners.
4. With long hex-head screws from toilet oor bracket kit,
fasten oor brackets with 3/8 in. (10 mm) socket wrench,
using corner marks as guides (g.
11
).
12
10
11
Note
Do not completely tighten hex-head screws to oor – allow
brackets to slightly slide. Brackets will tighten when fastening
toilet to brackets.
SeaLand MasterFlush Toilet Installation
(88 Seiten)
(172 Seiten)
(21 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern