Dometic EA0610 Bedienungsanleitung PDF herunterladen (Seite 6)

6. Ice cubes

Fill the ice tray to 4/5 with drinking water, cover with the lid and place

the closed ice tray on the ice-tray shelf. Wipe off any excess water to

prevent the ice tray from freezing to the surface.

To speed up the making of ice cubes, turn the thermostat to position

MAX for a short while. Remember to turn the dial to its normal setting

when the ice cubes are frozen.

To remove the cubes from the ice tray, hold it under running water.

Remove the lid with the ice cubes from the ice tray and the ice cubes

can now be taken out easily.

7. Useful suggestion

Do not overfill the appliance. It is advisable to leave some space

between the products in the cabinet to ensure efficient and even

cooling. If the shelves are packed too tightly there may be

unacceptable temperature variations.

8. Defrosting, cleaning and

maintenance

Frost will gradually form on the cooling surfaces and it must not be

allowed to become too thick since it acts as an insulator and interferes

with the cooling.

This frost-formation is kept back by the FUZZY LOGIC system built into

the appliance by switching off the unit for two hours in every 24 hours.

The frost will melt and the defrost water will run through the drain tube

from the drip channel into an evaporating vessel located at the bottom

rear of the refrigerator at all models. (Fig 5) The defrost water will

evaporate automatically into the circulating air and the vessel will not

need emptying manually.

If we want to switch off the unit, turn the thermostat knob to "0",

disconnect the refrigerator from the electricity supply and leave the

cabinet door open. After defrosting the cabinet interior should be

wiped out with a clean, damp cloth.

9. Reversing the door hang, (Fig. 6)

The direction the door opens can be transferred from one side to the

other by carrying out the following steps:

disconnect at the mains

lay the refrigerator down carefully on its back

remove the lower hinge  and detach the door

remove the two upper left-hand screws and detach the covering

plate  by pulling it forward

detach the upper hinge and mount it on the opposite side

remove the hinge bolt and screw it in from below

insert the covering plate in the upper right-hand corner by

pushing it in and secure it with the two screws

position the door on the upper hinge bolt and mount the lower

hinge

ensure the door can move freely and the seal is correctly

positioned.

10. Replacing the decorative door

panel,

(Fig. 7-9)

Remove the two screws (1) from the upper hinge of the door.

Pull the door together with the hinge away from the housing and up

off the lower hinge bolt (2-3).

Remove screws (4) and pull off the frame edge (5).

Slide the decorative panel (6) out of the door frame and insert the

new panel (7), so that the upper edge of the panel runs exactly

parallel to the upper edge of the frame. A new panel can be

inserted more easily into the upper edge of the frame when the

two corners are cut off by approx. 5 x 5mm (8). Put the frame edge

(5) back in place and secure with screws.

Place the door on the lower hinge (9), slot the upper hinge into the

opening, press together with the door against the housing and

secure with the two screws (11).

Figure 6.

Figure 5.

Figure 7.

Figure 8.

Figure 9.

1 2 3 4 5 6 7 8 9

Kommentare zu diesen Handbüchern

Keine Kommentare

Dometic EA0610 Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Dometic EA0610