Dometic DW2410 Bedienungsanleitung PDF herunterladen (Seite 15)

- 15 -

Installation

Positioning

The dishwasher is intended to be installed on a kitchen

drainer or worktop. To function properly, make sure that

the appliance is level. Its height can be adjusted with the

adjustable feets (8 mm each).

Water inlet

The temperature of the water supply should not exceed

65° C and the pressure should be between 50-1000 kPa

(0,5 - 10 bar).

It is important to have a tap or stopcock, positioned close

to the dishwasher and with easy access. Special mixer

taps with dishwasher connections are available, as well as

adaptors for older mixer taps. Connect the inlet hose to a

tap with a 3/4" pipe thread. If necessary, use the restrictor

(1/2") supplied.

The inlet hose must not be joined onto any form of extension

hose. If it is too short, the entire hose must be replaced

with a longer high-pressure hose, specially designed for

the purpose. The end of the hose, which is connected to

the dishwasher can be turned in any direction. Loosen the

retaining nut, turn the hose, then retighten the nut.

Check that the nut and all other connections

are tight before the machine is moved into

position.

Use only the inlet hose supplied to the dish-

washer, do not reuse the old inlet hose.

Water drainage

Place the discharge hose over the sink as illustrated.

It must not at any point be higher up than 75 cm over the

surface which the dishwasher is standing on. If it runs higher,

operation of the dishwasher might be impaired.

It is also important to ensure that the inside diameter of the

hose is not less than 13 mm at any point. If the discharge

hose is too long, it can easily be cut to the right length.

1. Cut the hose to a suitable length, using a sharp

knife.

2. Fit the elbow supplied onto the end of the hose.

Electrical connection

The dishwasher is supplied with a lead and electrical plug

for connection to a 230 V earthed wall socket, which should

be easily accessible and protected by a 10 A fuse.

Before any work is carried out on the dish-

washer, it must be isolated from the electric

mains supply, for example by removing the

plug from the wall socket.

Permanent electrical installation must be

carried out by an authorised electrician or

competent person.

1 2 ... 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Dometic DW2410 Bedienungsanleitung Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Geschirrspüler Dometic DW2410