Dometic RM2410 Bedienungsanleitung PDF herunterladen (Seite 6)

- 6 -

INSTALLATION INSTRUCTIONS

INSTALLING REFRIGERATOR

Make sure the oor is solid and level.

The refrigerator must be installed in a substantial enclosure

and must be level.

Do not install the appliance directly on carpeting. Carpet-

ing must be removed or protected by a metal or wood panel

beneath the appliance, which extends at least full width and

depth of the appliance.

All areas within the recess in which the refrigerator is

installed must be sealed. Make sure that there is a complete

seal between the front frame of the refrigerator and the

top, sides and bottom of the enclosure. A length of sealing

strip is applied to the rear surface of the front frame for this

purpose. Also, apply a sealing strip to the foremost oor of

the enclosure. The sealing should provide a complete isola-

tion of the appliance’s combustion system from the vehicle

interior. Be careful not to damage the sealing strip when the

refrigerator is put in place!

SECURING THE REFRIGERATOR

It is important to follow the sequence in securing refrigerator in

enclosure since failure in doing that can cause leakage between

the frame and cabinet!

Any space between the counter, storage area or ceiling and top

of the refrigerator greater den 1½ inches should be blocked.

The heat produced at the rear of the refrigerator will become

trapped in this space, making the top of the refrigerator hot and

reduce the efciency of the refrigerator.

After the refrigerator has been installed (ensuring a combustion

seal at the front frame), the refrigerator is to be secured in the

enclosure with six screws (not included).

Install the six screws in the following order:

Two screws installed through the front base.

Two screws installed in the top frame.

Two screws installed in the rear base.

CONNECTIONS

GAS CONNECTION

Hook up to the gas supply line is accomplished at the manual

gas valve, which is furnished with a 3/8” SAE (UNF 5/8” -18)

male are connection. All completed connections should be

checked for leaks with a non-corrosive commercial bubble

solution

•

3 rd.

2 nd.

1 st.

The gas supply system must incorporate a pressure regulator

to maintain a supply pressure of not more than 11 inches water

column. When testing the gas supply system at test pressures:

> 1/2 psi - the refrigerator and its individual shutoff valve

must be disconnected from the gas supply piping system.

≤ 1/2 psi - the appliance must be isolated from the gas sup-

ply piping system by closing its individual manual shutoff

valve.

If detailed instructions on the installation and connection to the

gas supply are required, contact your dealer or distributor.

•

EXPLOSION HAZARD. Never use an open

ame to check for gas leaks. Failure to heed this

warning could cause an explosion resulting in

death or severe personal injury.

WARNING

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Dometic RM2410 Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Dometic RM2410