Dometic RM2410 Bedienungsanleitung PDF herunterladen (Seite 8)

- 8 -

MOUNTING THE DOOR PANEL

The refrigerator is normally delivered without door panel. Be-

fore mounting the door panel, read this instruction thoroughly

and check that the panel dimensions are in compliance with

those given in the table below.

Panel dimensions

max. thickness 5/32" (4 mm)

Model Height

max min

Width

max min

RM2410

697 695 515 513

inch

27-7/16 27-23/64 20-9/32 20-13/64

RM2510

897 895 515 503

inch

35-5/16 35-15/64 20-9/32 20-13/64

To mount the panel, follow these steps:

Open the door 90 degrees.

On new refrigerators, the decoration strip is taped

inside the door; if installed on the door, remove

the door decoration strip (2) by removing its two

screws (1).

Insert one vertical edges into the groove of the door

frame (3).

Bend the panel gently so that the free side of the

panel can be slipped into the corresponding groove

of the door frame (4). Slide the panel down into the

groove of the bottom frame (5).

Between the upper edge of the panel and the door

frame there is a gap which should be covered by the

decoration strip.

Put the decoration strip across the door so that the

gap is covered and push it upward (6). The tabs on

the inside of the strip should t behind the ange of

the door frame.

Secure the decoration strip with the two screws

removed in step 1.

MOUNTING INSTRUCTIONS

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Keine Kommentare

Dometic RM2410 Bedienungsanleitung Seite 8