Dometic B3200 Bedienungsanleitung PDF herunterladen (Seite 7)

1. You may either wire direct into the junction box for

a permanent connection or wire a molded plug into

the junction box for a plug-in connection.

a. If a Permanent Connection: Route the power

supply line, previously installed to the roof

opening, into the junction box on the ceiling

template. Connect as described in paragraph 2.

b. If a Plug-in Connection: Use the electric supply

line, of "D. Wiring Requirements", to power and

electrical outlet installed, according to appli-

cable law, at the end of the roof opening furthest

from the junction box.

Important: Do not plug the molded cord in until you

have completely installed the air conditioner and are

ready for an operational check. (Operating Instructions)

• Route the molded plug set from the electric

outlet into the junctions box insuring not to

coil excess wire so it will block air flow.

Connect the plug set to the terminal block

as described in paragraph 2.

2. Connect the power supply line to the air conditioner

at the terminal block provided in the junction box.

Connect white to white, black to black and green to

green or bare copper wire (L. N. and respectively).

3. Tighten the strain relief onto the power supply line to

hold firmly in place. Be careful not to pinch and short

wires.

Note: If optional electric heater is part of this installation, now

is the time to install it. Installation instructions are provided

with the electric heater kit.

4. Carefully push all excess wire back into the junction

box and install cover onto the box with two blunt

screws provided.

5. Plug the electrical conduit from the upper unit into

the mating switch box connector. See FIG. 13.

6. Wrap wire tie around plug connector(s) to prevent

removal in field service.

FIG. 13

Route Power Supply

Through Romex

Connector

Plug Conduit Into

Switch Box And

Secure With Wire

Tie To Prevent

Removal

Install

Cover

H. Air Distribution Box Installation

1. Remove the two return air grills and filters.

2. Slide the front end of the air box over the shafts of

the thermostat and selector switch. See FIG. 14.

FIG. 14

Slide Air Box over Controls

3. Install four screws through legs in air box into the

pre-punched holes in the ceiling template.

4. Install the return air grills and filters by simply push-

ing them into place.

5. Install the two knobs provided on the ends of the

thermostat and selector switch shafts.

6. The power supply to the air conditioner may now

be turned "ON".

7. Your air conditioner is now installed and ready for

operation. Please read the following instructions be-

fore attempting to run the unit.

OPERATING INSTRUCTIONS

A. Controls

1. The Selector Switch has eight positions including

"OFF". This controls fan speed, heating mode, and

cooling modes. See FIG. 15.

FIG. 15

Selector Switch

FIG. 16

2. The thermostat controls the compressor ON/OFF

operation in cooling temperature range of 18.5° C to

32.5° C. See FIG. 16.

Note: The thermostat does not control the unit optional

electric heater if installed.

Thermostat

1 2 3 4 5 6 7 8 9 10

Kommentare zu diesen Handbüchern

Keine Kommentare

Dometic B3200 Bedienungsanleitung Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Dometic B3200