Dometic RM7851L Bedienungsanleitung PDF herunterladen (Seite 21)

Installation recess

The refrigerator must be installed draught-free in a recess (see “6.2”).

The measurements of the recess are given in the table below. Push the appliance far

enough into the recess until the front edge of the refrigerator casing is flush with the

front of the recess. Allow a gap of 10-20mm [3/4”] between the back wall of the recess

and the refrigeration unit. The floor of the recess must be level, allowing the appliance to

be pushed easily into its correct position. The floor must be substantial enough to

bear the weight of the appliance (no hollow space underneath).

Ensure that the refrigerator is installed level in the recess.

Recess measurements:

Securing the refrigerator

In the sidewalls of the refrigerator, there are four plastic

sleeves with screws for securing the refrigerator. The

sidewalls or rails attached for securing the refrigerator

must be designed in such a way that the screws will

remain firmly in place even when under increased load

(while the vehicle is moving).

Always insert screws through the sleeves provided;

otherwise, structural parts embedded in the foam,

such as cables, etc., may be damaged.

Once the refrigerator is in its final position, secure the

screws into the wall of the recess.

The screws must penetrate

through the sheet metal

casing of the refrigerator.

6.5

6.6

RM 7651 1248 mm 530 mm 510 mm

49-3/20” 20-17/20” 20-1/10”

Model Hight H Width W Depth T

Width of recess = W

Stopper strips for example are affixed

in the installation bay, at the sides, at

the bottom and at the top and are fitted

with flexible sealant strips

Affix strip to side wall.

Seal i.e.V seal.

plan view

Width of recess = W

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Keine Kommentare

Dometic RM7851L Bedienungsanleitung Seite 21